1. Add Image - Click to upload a new image. Select FileRemoveThe file must be a JPG or PNG image with a size up to 3Mb and no more than 2000x2000 pixels.

2. Add from Library - Click to pick an image from your image Library.

3. x Delete - To delete an Annotation card.

4. Text Search... - to search through the annotation cards.

5. Cards for the Measurement Guides on the project will be listed here.

6. Your selected image for the relevant card will be displayed here, and annotations can be applied within this area.

7. Expand - click to expand the annotation area and annotation lines to fill the screen. (you can then shrink it to regular size again if needed)

8. Additional Options:

9. Click to collapse or expand the details.

10. Comments - Add in any additional comments which aren't specific to an annotation line here. (1050 Character limit)

11. Measurements List - All measurements will pull through to here from the measurements listed on the Measurements and Grading tab, click on the measurement you would like to annotate and the below modal will open prompting you to click and drag to draw your line.

        1. Label - The letter/number for that annotation line.

        2. Description - The annotation line description (170 character limit).

        3. Colour - Choose a colour for the annotation line.

  4. Type - Choose from a straight or curved line. When choosing the curved line you will need to click and drag to position the curve using the 2 points in the centre of the line.

    5. Start - Choose how the line should start.

  6. End - Choose how the line should end. (same options as above)

  7. Delete Measurement - Click to remove the drawn annotation line.

Once you have drawn a line for each measurement line - each line will fill in the chosen colour and a tick will be displayed to indicate that this is complete.